Tools Required - EXIT Toys Spinner Mode D'emploi

11 M8X17 Bolt
4 pcs
13 M8X62 Bolt
SAFETY INSTRUCTIONS
4 pcs
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions
carefully. check entire box and inside all packing material for parts and/or additional instruction
15 M6X15 Bolt
material. Before beginning assembly, read the instructions and identify parts using the hardware
2 pcs
identifier and parts list in this document. proper and complete assembly, use, and supervision are
essential for proper operation and to reduce the risk of accident or injury. A high probability of
serious injury exists if this system is not installed, maintained, and operated properly.
• a recommendation to place the toy on a level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, overhanging branches, laundry lines or electrical
wires;
18 M8 Washer
• detailed instructions on how anchors are to be installed to prevent overturning or lifting of the
support members during normal or foreseeable misuse also taking into account the condition of
4 pcs
the soil normally encountered;
• instructions that anchors shall be placed level with or under the ground in order to reduce
tripping hazards;
• instructions that toys (for example swings, slides, climbing frames) shall not be installed over
concrete, asphalt or any other hard surface;
6mm Hex Key
• a recommendation on the orientation of the toy in relation to the sun (e.g. slides);
1 pc
• information to keep assembly and installation instruction for further reference.
Most injuries are caused by misuse and/or not following instructions.
TOOLS REQUIRED / ERFORDERLICHES WERKZEUG / BENODIGD GEREEDSCHAP / OUTILS NECESSAIRES
•
Two (2) Capable Adults
• Tape Measure
• Hammer
4
16 M8 Cap Nut
12 pcs
19 M8 Spring Washer
4 pcs
L-Screwdriver
1 pc
Use caution when using this system.

TOOLS REQUIRED

12 M8X50 Bolt
8 pcs
14 M10X75 Bolt
1 pc
17 M10 Cap Nut
1 pc
20 Spare cap
1 pc
Wrench
1 pc
• Large and Small
Adjustable
Wrenches
• #2 or #3 Phillips
Screwdriver
• Safety Glasses
21