Final Inspection; Winter Storage; Warranty Conditions; Technical Data - Vetus V-Quipment High Performance Zero Feedback Instructions D'installation

12 Final inspection

Check the following points before test operation:
• The radius of the cable is nowhere less than 200 mm (8"). (See 10
Installing the cable)
• Make sure the direction of rotation of the steering wheel matches
the direction the boat will turn. (See 9 Entering cable)
• Make sure that the end stops of the motor coincide with a cable
travel. (See pg. 31)
• Check that all nuts and bolts are tightened to the specified torque.

13 Warranty conditions

Failure to comply with the following conditions will cancel any claim
on the warranty and Vetus B.V. will not assume responsibility for any
resulting damage.
- the steering system is installed together with an outboard motor
with a power which exceeds de maximum horsepower rating of
the boat,
- the steering system has been used for an application other than
that stated in the manual,
- the steering system has been improperly fitted or installed,
- there is a case of normal wear and tear,
- the conditions concerning operation, maintenance and repair
have not been followed,
- the steering system has been used differently from what could
normally be expected.
14 Maintenance
Checking and maintenance should be carried out:
- at least once per month when used in salt water areas
- at least once per 3 months when used in fresh water areas.
Check and service the following:
14.1 Cable output end
Check all metal parts and the cable output end for corrosion. Remove
any old grease from the cable ram and motor swivel connections us-
ing a mild solvent, such as kerosene. Spray the cleaned areas with a
moisture-displacing lubricant such as WD-40 or equivalent and apply
a light coat of good quality marine grease. Do this with the cable ram
fully extended.
14.2 Cable
Check the entire cable conduit for cracks or abrasion of the plastic
cover. Replace the cable if needed.
High Performance Zero Feedback Cable Steering
14.3 Helm
Check all fasteners such as bolts and nuts for tightness.

14.4 Winter storage

In winter storage or used infrequently, clean the cable ram per the
previously mentioned instructions. Cycle the steering several times
when applying lubricant.
If at any time the steering system becomes stiff, has an excessive
amount of backlash or shows any change in its operating character-
istics, it is recommended to have the system checked by authorized
dealer.
- Helm contains no internal field serviceable parts.
- Any attempt at disassembly of these units will void warranty
of this product.

15 Technical data

Type : Rotary steering system for 1 outboard
Mounting bezel : 90° alternative 20°
Suitable for : Boats up to 7.5 m (25 ft)
Outboards up to 90 kW (125 HP)
For single station use only
No. of turns steering
wheel H.O. to H.O. : 3.8
Max. wheel diameter : 381 mm (15"), with a max. wheel dish of
152 mm (6")
or
406 mm (16"), with a wheel dish of less
than 50 mm (2")
Wheel shaft : 19 mm (
Weight, helm unit : 1.9 kg (4.2 lbs)
Cable,
- Travel : 230 mm (9")
- Lengths : 153 to 610 cm (5 to 20 ft)
in steps of 31 cm (1 ft)
- Min. bend radius : 200 mm (8")
- Max. loop : 360°
- Weight : 1.5 m ... 6.1 m ⇒ 1.25 kg ... 4.8 kg
3 ft ... 20 ft ⇒ 2.8 lbs ... 10.6 lbs
N !
ote
3 / ") dia., 1:12 taper
4
VQ12060_B
9