Working With The Config Window; Uploading Parameters To The Iaq Probe - Honeywell IAQ Probe Manuel De L'utilisateur

Working with the Config Window

The Config window is used mainly to configure the various settings
related to managing the data received from the IAQ Probe and to
upload parameters to the IAQ Probe.

Uploading Parameters to the IAQ Probe

Setting Acquisition Time
The acquisition time is the interval, in seconds or minutes, at which the
IAQ Probe will record sensor data. You can select any number from 1
to 99 and specify whether in minutes or in seconds.
Clicking on Set within the Acquisition Interval Delay window opens a
DAQ warning window.
• Click Download then set DAQ time if you wish to save the IAQ
Probe's data and set the Acquisition Time.
• Click Set DAQ time now if you wish to set the Acquisition Time and
clear the IAQ Probe's memory without uploading it.
• Click Cancel to exit this function without any changes (will not clear
the memory or set the acquisition time).
Note: If you select Download then set DAQ time and click Cancel within
the "Save data to..." window, the acquisition time will not be set
and the memory will be cleared without saving.
511403
2/07
IAQ Probe User Manual
Honeywell
Using the IAQ Probe Software
Working with the Config Window
51