GE 19 Manuel D'utilisation page 16

Installing the water line.
Read these instructions completely and carefully.
Shut Off the Main Water Supply
Turn on the nearest faucet long enough to clear the line of water.
Install the Shutoff Valve
1 Install the shutoff valve on the nearest
frequently used drinking water line.
Choose a location for the valve that is easily
2
accessible. It is best to connect into the side of a
vertical water pipe. When it is necessary to
connect into a horizontal water pipe, make the
connection to the top or side, rather than at the
bottom, to avoid drawing off any sediment from
the water pipe.
Drill a 1/4" hole in the water pipe, using a sharp
3
bit. Remove any burrs resulting from drilling the
hole in the pipe.
Route the Copper Tubing and Connect It to the Shutoff Valve
Route the copper tubing between the cold water
line and the refrigerator.
Route the tubing through a hole drilled in the wall
or floor (behind the refrigerator or adjacent base
cabinet) as close to the wall as possible.
Be sure there is sufficient extra tubing [about 8
feet (244 cm) coiled into 3 turns of about 10 "
(25 cm) diameter] to allow the refrigerator to
move out from the wall after installation.
Turn On the Water and Flush Out the Tubing
Turn the main water supply on and flush out the
1
tubing until the water is clear.
16
Fasten the shutoff valve to the cold water pipe
4
with the pipe clamp.
Tighten the clamp screws until the sealing
5
washer begins to swell.
Do not overtighten or you may crush the copper
tubing.
Washer
Pipe Clamp
Saddle-Type
Shutoff Valve
Place the compression nut and ferrule (sleeve)
onto the end of the tubing and connect it to the
shutoff valve.
Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.
Saddle-Type Shutoff Valve
Packing Nut
Outlet Valve
Shut the water off at the water valve after about
2
one quart (1 L) of water has been flushed
through the tubing.
Inlet End
Vertical Cold Water Pipe
Compression Nut
Ferrule (sleeve)