Performance Data Sheet - GE 19 Manuel D'utilisation

Performance Tested to NSF/ANSI*
(100% safety factors built in for unmetered usage)
Parameter USEPA
MCL
Chlorine
T & O
Particulate**
* Tested using a flow rate of 0.5 gpm; pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 20° ± 2.5°C
** Measurement in Particles/ml of 10µ Particles
Operating Specifications
Capacity: certified for up to 250 gallons (946 L)
Pressure requirement: 40–120 psi (2.8–8.2 bar), non-shock
Temperature: 33°–100° F (0.6°–38° C)
Flow rate: 0.5 gpm (1.9 Lpm)
General Installation/Operation/Maintenance Requirements
Flush new cartridge at full flow for 60 seconds to purge out trapped air.
Replace cartridge when flow becomes too slow; at least every six months.
Special Notices
Installation instructions, parts and service availability, and standard warranty are included with the product when shipped.
This drinking water system must be maintained according to manufacturer's instructions, including replacement of filter
cartridges.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after
the system.
The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
Check for compliance with the state and local laws and regulations.
General Electric, Appliance Park, Louisville, KY 40225

Performance Data Sheet

Filtration by GE SmartWater
HXRT Cartridge
Standard No. 42: Aesthetic Effects
Influent
Challenge
— 1.96 ppm
— —
— 2296
Hotpoint
Effluent
Average Maximum
0.30 ppm 0.44 ppm
—
62
© 1997 GE
TM
% Reduction
Average
85
— —
116 97.3
Minimum
78
—
94.9
23