Installation Notes - EINHELL OPAL Instructions De Montage

Installation notes:

Page 7
Installation of the front wall assembly
1
Pre-assembly of the floor profile
Important note: For ease of handling, the front and
rear walls should be assembled flat on the ground.
Bottom illustration: Assembly preview of the front
wall with single door
Page 8
Top illustration: Front wall with double door
1/a: Slide the guide rails of the two floor profiles each
into one connecting part up to the corresponding
cutouts (see illustration.). Please refer to the relevant
assembly instructions for your greenhouse for the
exact position.
Page 9
1/c: Attach the floor gusset plate to the floor profile
using an additional bolt. Make sure that this bolt is
inserted on the left on the gusset plate mounted on
the left and on the right on the gusset plate mounted
on the right (see assembly preview details A and B).
Page 11
1/g: Make sure that the floor corner connectors are
flush with the floor profile as shown in Fig. 1/g.
Page 12
2
Assembly of the corner profiles
Page 13
Bottom illustration: Reference diagram (floor profile
with corner profiles): Internal view
Page 14
3
Pre-assembly of the gable profiles
Top parts list: Front wall with single door
Bottom parts list: Front wall with double door
Important note: This step is repeated later on during
assembly of the rear wall (see „Assembly of the rear
wall assembly"). Please make sure that the rear wall
is assembled in the same way as the front wall. Use
the corresponding components (parts list: front wall
with double door) and follow the corresponding steps.
Bottom illustration: Front wall with single door
Assembly preview / reference diagram (gable
profiles): Internal view
ABA_OSR_Teil1_Titel+GB.pmd 7
Observe the correct positions for the bolts.
Page 15
Top illustration: Front wall with double door
Assembly preview / reference diagram (gable
profiles): Internal view
Observe the correct positions for the bolts.
Fig. 3/a: Front wall with single door
Fig. 3/b: Front wall with double door
Page 16
Important note: Make sure that the assembly
panels are aligned in the way shown in the diagrams
3/c and 3/d. The assembly panels are not properly
aligned until the ridge and the rain guttering are
installed in a subsequent step.
Page 17
Important note:Make sure that the two (front wall
with single door) or three (front wall with double door )
pre-assembled bolts in the middle face inward.
Please check the corresponding reference diagrams
on the pages beforehand if you are unsure.
Page 18
Inspection page for the front wall with
single door
Before progressing to step 4, please use the diagram
below to check that all of the bolts required for the
next step have been installed.
Illustration: Internal view – front wall with single
door
Page 19
Inspection sheet for the front wall with
double door
Before progressing to step 4, please use the diagram
below to check that all of the bolts required for the
next step have been installed.
Illustration: Internal view – front wall with double
door
Page 20
4
Assembly of the gable profiles on the
corner profiles
04.04.2006, 15:08
7