EINHELL OPAL Instructions De Montage page 4

Masquer les pouces Voir aussi pour OPAL:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Information on use / base / base diagram
Information on use of the greenhouse
•All bolts, screws and nuts should be checked every three
months and retightened if required.
•After a storm or high winds please check all bolts, screws
and nuts and ensure that the plastic web panels are
correctly seated.
•In the event of a storm or heavy winds please close the
doors and windows of your greenhouse.
•Suitable storm anchoring (not included) should be used to
additionally secure the greenhouse in areas particularly
prone to storms.
•At temperatures below freezing (0 °C), never strike the
plastic web panels with hard objects.
•Snow should be cleared from the roof of the greenhouse on
a regular basis to prevent dangerous snow loads from
building up. A 10 cm layer of snow or a 2 cm layer of ice
can already be dangerous.
•The roof of your greenhouse is not designed to be walked on.
•Never use any naked flames or similar in the greenhouse.
Only use approved heating equipment.
•Always make sure that you comply with the local building
regulations in your area.
Base diagram
Concrete or brickwork base
Greenhouse
3 panels
4 panels
5 panels
6 panels
7 panels
Ba
La
4
ABA_OSR_Teil1_Titel+GB.pmd
La (cm)
Li (cm)
Ba (cm)
224
204
259
295
275
259
366
346
259
437
417
259
508
488
259
Bi
Li
4
Base
Please note: The greenhouse does not have a separate
base profile. You can erect your greenhouse on a previously
prepared brickwork or concrete base (see base diagram), or
you can assemble it on a steel base (available as an
optional accessory).
!
Important: : : : :
If you do not want to erect your greenhouse on
a masonry or concrete baseplate, ensure that
your greenhouse is built on level, sturdy ground.
Check levelness using a water level!
Concrete / brickwork base
It is very important for correct assembly of the greenhouse
that the right angles in the base are all perfectly square.
The base must be dead level, with perfectly square corners.
Please use a spirit level to check. Please note: the base
should be deep enough to be frostproof.
Bi (cm)
T (cm)
H (cm)
239
10
Frost-proof depth (30)
239
10
Frost-proof depth (30)
239
10
Frost-proof depth (30)
239
10
Frost-proof depth (30)
239
10
Frost-proof depth (30)
T
H
The base must be at least 10 cm
wide (T) with a height (as
required) of (h). The base must be
dead level, with perfectly square
corners.
04.04.2006, 15:04
h
H
10 cm

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

SmaragdRubin

Table des Matières