EINHELL OPAL Instructions De Montage page 11

reference diagrams for your greenhouse and
compare the pre-assembly steps (steps 19/a to 19/d)
with these illustrations before you insert the
struts.The roof struts with the bolts which have
been pre-assembled in the middle (see Fig. 19/b
and 19/d) will be required later on for assembly of the
window crossmember and the window. The
illustrations below show at which points the windows
are inserted in your greenhouse.
Bottom illustration: Reference diagram for the roof:
3-panel greenhouse
Key:
- Position of the pre-assembled bolts
- 1 bolt
Page 65
Top illustration: Reference diagram for the roof: 4-
panel greenhouse
Bottom illustration: Reference diagram for the roof:
5-panel greenhouse
Key:
- Position of the pre-assembled bolts
- 1 bolt
- 2 bolts
- Position of the already assembled gusset plates
on the ridge and the rain guttering
Page 66
Top illustration: Reference diagram for the roof: 6-
panel greenhouse
Bottom illustration: Reference diagram for the roof:
7-panel greenhouse
Key:
- Position of the pre-assembled bolts
- 1 bolt
- 2 bolts
- Position of the already assembled gusset plates
on the ridge and the rain guttering
Page 67
19/a: Please make sure you follow the assembly
instructions and refer to the reference diagram for
your particular greenhouse.
Page 69
19/e: First attach the side struts already assembled
in steps 19/c and 19/d to the gusset plates (side).
Insert the struts from the outside between the ridge
and the rain guttering.
Page 71
20
Assembly of the window rabbet profile
ABA_OSR_Teil1_Titel+GB.pmd 11
Page 72
20/b: Insert the window rabbet profile from inside
between the side struts (roof) with the bolts already
pre-assembled in the middle (see reference
diagrams in step 19). Make sure that the cutouts for
the bolts face downward (see Fig. 20/c).
Page 73
21
Assembly of the gusset plates
Important note: If you have purchased a 3-panel
greenhouse, skip step 21 and continue with
assembly step 22.
21/a: Attach the gusset plates at an angle of 120° to
the struts on which the bolts have been pre-
assembled.
Page 74
21/b: To finish with, attach a gusset plate at an angle
of 120° to the roof struts on which the bolts have
been pre-assembled.
Page 75
22
Assembly of the side wind bracing
Note: During assembly of the side wind bracing,
please make sure that you insert these wind bracing
elements as described in the relevant assembly
previews / reference diagrams (side).
Bottom illustration: Assembly preview / reference
diagram (side): 3-panel greenhouse
Page 76
Top illustration: Assembly preview / reference
diagram (side): 4-panel greenhouse
Bottom illustration: Assembly preview / reference
diagram (side): 5-panel greenhouse
Page 77
Top illustration: Assembly preview / reference
diagram (side): 6-panel greenhouse
Bottom illustration: Assembly preview / reference
diagram (side): 7-panel greenhouse
Page 79
23
Assembly of the roof wind bracing
Note: During assembly of the roof wind bracing,
please make sure that you insert the wind bracing
elements as described in the relevant assembly
previews / reference diagrams (roof). This is
essential for providing the required stability for the
greenhouse.
04.04.2006, 15:08
11