ASCOM Ascotel Office 100 Mode D'emploi page 156

Using the extended-feature functions
Requesting a callback
You request a call back from an internal subscriber whose line is busy or who is not
answering.
Note
Only one call back can be activated at a time.
Sending a message
Standard messages are stored in the PBX. After failing to reach a subscriber, you can
select one of these messages, add to it or change it if necessary and then send it to the
subscriber or a group you are trying to reach.
Msg.
M
1 2
4 5
7 8
C
C
0
1 2
4 5
7 8
0
Notes
• This procedure can also be initiated with "Dialling preparation", i.e. enter the number
first and then select the message.
• If you wish, you can also delete the entire message with the C-key and write your
own.
18
C–back
Reset
¥
3
Ok
6
9
Ok
3
6
9
Press the Foxkey under "Call_back". The
message "Call expected from the number nnn"
appears in the display.
By pressing the Foxkey under "Reset" you can
cancel the requested call back.
Press the M-key repeatedly until "Message"
appears. Press the Foxkey under "Message".
Press the Foxkey repeatedly under "¥" until a
suitable message appears (i-symbol on the
display).
Press i-key once or several times to display the
entire message.
Edit the message using the C-key and the
alphanumeric dialling keypad (if necessary, see
"Dialling with a name").
Press the Foxkey under "Ok".
Dial the number of the subscriber/the group to
whom the message is directed. Press the Foxkey
under "Ok" to send the message.
20BA265311/B0