Starting And Stopping - Ryobi CS26 Manuel D'utilisation

TRI-ARC bLADE
®
The Tri-Arc blade is suited only for thicker weeds and pulpy
®
stalks. When the blade becomes dull, it can be turned over
to extend the life of the blade. Do not sharpen the Tri-Arc
blade.
CUTTINg TEChNIqUE - bLADE
WARNINg:
Extreme care must be taken when using blades to en-
sure safe operation. Read the safety information for safe
operation using the blade, refer to Specific Safety Rules
for brushcutter and blade Use earlier in this manual.
 Always hold brushcutter on your right side with both hands
when operating. Use a firm grip on both handles.
 Maintain your grip and balance on both feet. Position
yourself so that you will not be drawn off balance by the
kickback reaction of the cutting blade.
 Inspect and clear the area of any hidden objects such as
glass, rocks, concrete, fencing, wire, wood, metal, etc.
 Never use blades near sidewalks, fencing, posts, build-
ings or other immovable objects.
 Never use a blade after hitting a hard object without first
inspecting it for damage. Do not use if any damage is
detected.
 The unit is used as a scythe, cutting from the right to the
left in a broad sweeping action from side to side.
 Use only the Tri-Arc
®
blade or cutting head to this brushcutter can result in
serious personal injury.
OPERATION
blade. To install any other brand

STARTINg AND STOPPINg

See Figures 21 - 23.
To start a cold engine:
®
DO NOT squeeze the throttle trigger until the engine starts
and runs.
 Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the rope until the engine starts.
 Squeeze the trigger to run.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the RUN position.
To start a warm engine:
PULL the rope until the engine starts.
To stop the engine:
Press and hold the switch in the stop "
the engine stops.
12 — English
" position until