Connecting Audio Components; Plugging In; Rear Panel - Pioneer ELITE X-Z9 Mode D'emploi

Connecting up

Connecting audio components

The number and kind of connections depends on the kind of component you're connecting. Follow the steps below to
connect a tape deck, turntable or other audio component.
Tape deck, etc.
1
To analog
audio inputs

Rear panel

IN
IN
LINE
L
AC IN
R
OUT IN
LINE
4
Home Media Gallery
iPod
Music >
Extras >
Settings >
Shuffle Songs
Backlight
MENU
iPod
1 Connect the analog outputs of your tape deck (or
other recorder) to the LINE IN jacks on this receiver.
Then connect the audio inputs on the tape deck to the
LINE OUT jacks on this receiver.
This will allow you to make recordings from the
components connected to this receiver. Use stereo RCA
pin-plug cables as shown.
2 Turntables only: Connect the audio outputs of your
turntable to the PHONO IN jacks on this receiver.
• If your turntable has a grounding wire, secure it to the
ground terminal on this receiver.
• If your turntable has line-level outputs (i.e., it has a
built-in phono pre-amp), connect it to the LINE IN
jacks instead.
• Use only turntables equipped with MM type
cartridges.
3 Connect the front panel F.AUDIO IN mini-plug jack
to an auxiliary playback component.
These include components like a digital audio player or
the analog audio output of a PC. Connect using a
1
stereo mini-plug cable.
Note
1 The system automatically switches the input to FRONT AUDIO IN when you connect a mini-jack cable to the front panel (except when wake-up timer is
set for power ON).
Turntable
2
From analog
audio outputs
From analog
audio outputs
XM
RADIO
LAN
(10/100)
IN IN
PHONO iPod
Network
1
/ "
4
Front panel
TIMER DISPLAY OFF SOUND RETRIEVER
STANDBY/ON USB
USB mass
Router
strage device
(not suppulied)
4 Connect any iPods, USB mass storage devices, and/
or network components.
You can listen to music stored on such components from
Home Media Gallery (page 19).

Plugging in

Make sure to complete all connections before
connecting to an AC IN inlet.
Connect the AC power cord to the AC IN inlet on the rear
panel of the receiver, then plug into a power outlet.
F. AUDIO IN PHONES
3
Digital audio player, etc.
02
11
En