Connecting The Am And Fm Antennas; Connecting External Antennas - Pioneer ELITE X-Z9 Mode D'emploi

Connecting up
02

Connecting the AM and FM antennas

Connecting the supplied antennas will allow you to listen
to both AM and FM radio broadcasts. If you find that
reception quality is poor, an outdoor antenna should give
you better sound quality—see Connecting external
antennas right for more on how to do this.
1
ANTENNA
4
fig. a
1 Pull off the protective shields of both AM antenna
wires.
2 Push open the tabs, then insert one wire fully into
each terminal, then release the tabs to secure the AM
antenna wires.
3 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction
indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
• If you plan to mount the AM antenna to a wall or other
surface, secure the stand with screws (fig. c) before
clipping the loop to the stand. Make sure the
reception is clear.
4 Place the AM antenna on a flat surface and point in
the direction giving the best reception.
Don't let it come into contact with metal objects and
avoid placing near computers, television sets or other
electrical appliances.
5 Connect the FM wire antenna in the same way as
the AM loop antenna.
For best results, extend the FM antenna fully and fix to a
wall or door frame. Don't drape loosely or leave coiled up.
10
En
2
AM
FM UMBAL75
LOOP
FM antenna
AM loop antenna
3
fig. b fig. c

Connecting external antennas

External AM antenna
Use 15 ft. to 18 ft. (5 to 6 meters) of vinyl-insulated wire
and set up either indoors or outdoors. Leave the AM loop
antenna connected.
AM loop antenna
External FM antenna
5
Use a PAL connector to hook up an external FM antenna.
ANTENNA
ANTENNA
AM
FM UMBAL75
LOOP
Indoor
antenna
(vinyl-coated
wire)
15 ft. to 18 ft.
(5 m to 6 m)
PAL connector
AM
FM UMBAL75
LOOP