Saving Channel Presets; Using The Sirius Menu; Listening To An External Audio Source; Making An Audio Recording - Pioneer ELITE X-Z9 Mode D'emploi

Other connections
07

Saving channel presets

This receiver can memorize up to 30 channels, stored in
three banks, or classes (A, B and C) of 10 stations each.
1 Select the channel you want to memorize.
See Selecting channels and browsing by genre on
page 31.
2 Press T.EDIT .
The display shows a blinking memory class.
3 Press CLASS to select one of the three classes then
press to select the channel preset you want.
You can also use the number buttons to select a preset.
4 Press ENTER .
After pressing ENTER, the preset class and number stop
blinking and the receiver stores the SIRIUS channel.
Tip
• You can also press MEMORY during reception
display to save the information of up to 5 songs. See
Using the SIRIUS Menu below to recall this
2
information.
Listening to channel presets
You will need to have some presets stored to do this.
1 Press CLASS to select the class in which the channel
is stored.
Press repeatedly to cycle through classes A, B and C.
2 Press to select the channel preset you want.
• You can also use the number buttons on the remote
control to recall the channel preset.

Using the SIRIUS Menu

The SIRIUS Menu provides additional SIRIUS Radio
2
features.
1 Press TOP MENU .
2 Use to select a menu item then press ENTER .
Choose between the following menu items:
• Memory Recall – Use
song information (see Tip above).
• Channel Skip/Add – Use
channels you would like to remove/restore from/to
the channel guide.
• Parental Lock – Use
channels you would like to place under parental lock.
Channels put under parental lock are not displayed in
the Channel Guide, but may be accessed by directly
inputting their channel number and providing the
parental lock password.
• Antenna Aiming – Check the strength of satellite
and terrestrial reception.
• Password Set – Set the parental lock password.
Note
1 Note that channels locked out with parental lock cannot be saved on this receiver.
2 You can reset the Channel presets, Memory, Channel Skip/Add, Parental Lock and Password settings in Resetting the system on page 35.
3 The receiver's volume, balance and tone controls have no effect on the recorded signal.
32
En
1
2
to browse your saved
and ENTER to select
and ENTER to select
3 When you're finished press TOP MENU to return to
the reception display.

Listening to an external audio source

To listen to audio from a connected external component
on this receiver, choose its input function on the remote
control.
For more information on how to connect external
components, see Connecting audio components on
page 11.
• When you connect a cable to the F.AUDIO IN jack,
this unit's input automatically switches to FRONT
AUDIO IN.
1 Turn on the power of the playback component.
2 Turn on the power of the receiver.
3 Press INPUT until you have selected the source you
want to play back.
4 Start playback of the component you selected in
step 1.

Making an audio recording

You can make an audio recording from any audio source
connected to the receiver.
1 Select the source you want to record.
2 Prepare the source you want to record.
Tune to the radio station, load the CD, set up the
turntable, etc.
3 Prepare the recorder.
Insert a blank tape, MD, etc. into the recording device
and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this.
4 Start recording, then start playback of the source
component.
3