Cleaning The Receiver's Exterior; Cleaning The Speakers' Exterior; Cleaning The Pickup Lens; Condensation - Pioneer ELITE X-Z9 Mode D'emploi

Additional information

Cleaning the receiver's exterior

Unplug the unit before cleaning.
Use a dry cloth to wipe off dust and dirt. If the surfaces
are very dirty, wipe with a soft cloth dipped in some
neutral cleanser diluted five or six times with water and
wrung out well, then wipe again with a dry cloth.
Do not use furniture wax or cleaners. Never use thinners,
benzine or insecticide sprays or other chemicals on or
near this receiver.
If you use a chemical-impregnated cleaning cloth, read
the instructions carefully before use. These cloths may
leave smear marks on half-mirror finish surfaces; if this
happens, finish with a dry cloth.

Cleaning the speakers' exterior

For normal cleaning, use the provided cleaning cloth. The
speakers have been treated with a piano polish to
preserve the finish, with the result that when the speaker
is first unpacked, the surface may appear to be smeared
or uneven. In this event, use a soft damp cloth to wipe the
entire surface, then dry by wiping with a dry cloth.
• Use commercially available piano polish to clean the
speakers (glossy finish). Do not allow alcohol,
thinner, benzene, or insecticides to come into
contact with the surface, since finish discoloration
may occur. Also, when using chemically
impregnated cleaning cloths, follow their
precautions carefully.

Cleaning the pickup lens

The player's lens should not become dirty in normal use,
but if for some reason it should malfunction due to dust
or dirt, consult your nearest Pioneer-authorized service
center. We do not recommend using commercially
available lens cleaners for CD players.

Condensation

Condensation may form inside the player if it is brought
into a warm room from outside, or if the temperature of
the room rises quickly. Although the condensation won't
damage the player, it may temporarily impair its
performance. Leave it to adjust to the warmer
temperature for about an hour before switching on.

Moving the receiver

If you need to move the player, first switch the unit into
standby (press STANDBY/ON on the remote control),
then unplug the power cable. Never lift or move the unit
during playback—discs rotate at a high speed and may
be damaged.
11
37
En