Kemper KHS Hygiene Flush Box PRO Instructions D'installation Et D'utilisation page 23

1.4 Function
PURE controller
LITE controller
The PURE version of the controller is operated via the built-in
rotary push-button. The interval between two flushing cycles,
together with the flush duration of a flushing cycle, can be set on
the controller. The V1 and V2 LEDs serve as status indicators for
the respective water exchange group. The displays above are for
the interval between the flushing cycles and the flush duration
of the flushing cycles. Flow and temperature values cannot be
logged with this controller version.
Danger! Electricity!
• We advise connecting an 0.03-A residual-
current device upstream for personal
protection.
Info - PURE status lights
V1 / V2
green
yellow
blue
red
red & blue
Interval time (h) + flush duration (min)
green
flushing green
The LITE version of the controller does not contain any operating
or display elements and does not have its own flushing logic.
To use the functions of a controller, it must be operated via an
external building management system (BMS). The controller is
connected to the flow/temperature sensor and can transmit data
on flow rate and temperature. The flushing cycles are controlled
by controlling the solenoid valves via the BMS.
© www.kemper-olpe.de – 08.2021 / K410068903002-00 – 23 /108
In function
Water exchange group selection
Flushing active
Error
Flushing active and current error
Selection
Selection confirmed
EN