Before Initial Use; Charging Up The Battery - DS Produkte MAXXMEE K1201 Mode D'emploi

EN

BEFORE INITIAL USE

• Thoroughly rinse all accessories before you first use
them in order to remove possible production residues
(Picture B). To do this, follow the instructions in the
"Cleaning and Storage" chapter.
• Charge up the battery fully before you first use the device
so that it reaches full capacity (see the "Charging Up the
Battery" chapter).

CHARGING UP THE BATTERY

Please Note!
■
Do not charge up on a computer because the computer
might be damaged by the high charging current.
If the control lamp (7) flashes, or if the device can no longer
be switched on, the battery is too weak and needs to be
charged.
The device should preferably be charged at a plug socket
using a USB mains adapter (not supplied with the device).
1. Plug the connector of the USB cable into the USB sock-
et (1) of the motor unit (2) (Picture C).
2. Connect the USB cable to a USB mains adapter and then
connect this to a plug socket.
The charging process begins and the control lamp lights
up red. When it goes out, the battery is charged.
3. Pull the USB mains adapter out of the plug socket and
then pull the USB cable out of the device.
22