Whirlpool GY399LXUS Instructions D'installation page 8

4. Add strain relief.
Style 1: Power supply cord strain relief
Assemble a UL listed strain relief in the opening.
A. UL listed strain relief
Feed the power supply cord through the opening in the
cord/conduit plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
Use Phillips screwdriver to remove screws from panel on
back of range.
8
A
E TAG! E TAG! USE CORD CORD USE CORD
WITH REMOV WITH WITH REMOV LA POWER POWER LA POWER ETIQUE ETIQUE TA EL TA S EL
NUTS NUTS NUTS QUITE USE QUITE CONEC N ELÉCTR N ELÉCTR CONEC LAS TAR TAR TUERCA ICO ICO
PARA PARA CORDÓ CORDÓ
Lift range back panel up and off.
USE USE CORD
REMOV REMOV E TAG! WITH WITH E TAG! WITH POWER POWER ETIQUE ETIQUE POWER TA S TA CORD CORD
NUTS NUTS NUTS QUITE QUITE LAS LA LA TUERCA EL ICO TAR EL TAR ICO
PARA CORDÓ PARA CORDÓ USE N ELÉCTR N ELÉCTR CONEC CONEC
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
Position cord/conduit plate as shown in the following
illustration.
Replace cord/conduit plate and insert screws.