Setting Mode; Changing Settings - Esoteric N-05XD Mode D'emploi

Setting mode

The settings for this unit are divided into three groups: MENU 1,
MENU 2 and MENU 3 .
MENU 1, MENU 2 or MENU 3 settings will be shown depending on
how the MENU button is pressed .

Changing settings

1
Press the MENU button.
MENU 1 will be shown .
To show MENU 2, press and hold the MENU button .
To show MENU 3, press and hold the ; setting adjustment but-
ton while gotoMENU3 is shown in MENU 2 .
2
Press the MENU button repeatedly to select the
item to change.
Each time you press the MENU button, the item shown on the
display changes as follows .
MENU 1 MENU 2
BAL> PCMF>
c c
LVL> PCMΔΣ>
c c
CLK> DSDF>
c c
VOLDP> LanLED>
c c
LOUT> NETin>
c c
DPaOFF> BTstby>
c c
APS> F/W ver .
c
gotoMENU3
o If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume .
o Depending on the selected source and operation status,
some items might not appear .
24
3
4
When the remote control AMP button setting
(AMPRM>) is ON
L/R balance (BAL>) and input gain (LVL>) adjustments will not be
shown in MENU 1 .
Follow these procedures to change these settings .
o The buttons in the AMP section on the remote control must be
MENU 3
L_VOL>
1
c
THRU>
c
MTLV>
c
AMPRM>
2
c
RS232C>
c
TRIG_O>
3
Use the setting adjustment (l/;) buttons to
change the settings.
To change multiple items, repeat steps
o Press the ; setting adjustment button when "F/W ver . " is
shown to check the versions of other firmware .
Press the ; setting adjustment button when the FPGA ver-
sion is shown to return to showing F/W ver .
Press the INPUT button to end setting mode.
Setting mode will also end and the ordinary display will reappear
if nothing is done for ten or more seconds .
o Settings are retained even if the power plug is disconnected .
used (page 17) .
Press the SETUP button to show the setting to
be changed.
Pressing the SETUP button switches between showing BAL> and
LVL> .
Use the INPUT (l/;) buttons to change the
setting.
Press the SETUP button several times to return
to ordinary display and complete the setting.
o The INPUT button on the unit can also be pressed to com-
plete the setting .
2 3
and .