Dimmer - Esoteric N-05XD Mode D'emploi

AMP section
When the remote control AMP button setting (AMPRM>) is ON,
the k–n buttons in the AMP section will be enabled (page 30).
o When using an ESOTERIC integrated amplifier or preamp, set the
remote control AMP button setting (AMPRM>) to OFF (page 30) .
k
INPUT (l/;) buttons
Use these to switch between input sources . Select the connec-
tor type that is connected to the desired audio output device .
Use these when changing L/R balance (BAL>) and input gain
(LVL>) settings (pages 24 and 25) .
l
SETUP button
Use these when changing L/R balance (BAL>) and input gain
(LVL>) settings (pages 24 and 25) .
m
VOLUME (+/−) buttons
Use these to adjust the volume . Press the + button to increase
the volume and the − button to decrease it .
o When "THRU" appears on the display, the volume cannot be
adjusted on this remote control (page 29) .
n
MUTE button
Press this to temporarily mute the sound . Press this again to
restore the volume setting .
o When muted, "MUTE" blinks on the screen .
o The buttons not explained here do not function with this product .
o This remote control can also be used for other ESOTERIC products .

Dimmer

This can be used to adjust the brightness of the main unit's display .
DIMMER 3
c
DIMMER 2 (normal brightness)
c
DIMMER 1
c
off
o Even when the dimmer is set to off, the display will light at normal
brightness for about three seconds when you press the play (7)
or another button .
o Even when set to DIMMER 1 or off, setting menus and error mes-
sages will be shown with normal brightness (DIMMER 2) .
o Pressing and holding the button will set the brightness to DIMMER 2
(normal brightness) .
17