Left And Right Balance Setting; Adjusting The Output Level - Esoteric C-02X Mode D'emploi

Balance and input level settings (continued)

Left and right balance setting

(Bal>***)
Adjust the balance between the left and right output channels.
You can set this to values between L 6.0 dB and R 6.0 dB in 0.5dB
increments. You can also set this so that just one channel is muted.
The default value is 0.0 dB (no balance adjustment).
Muting just one channel
Press the INPUT (k/j) buttons to select "Bal>R only" to output
only the right channel.
Likewise, press the INPUT (k/j) buttons to select "Bal>L only" to
output only the left channel.
o When the balance has been adjusted, the BALANCE indicator
lights to show this.

Adjusting the output level

(Level>***)
You can adjust the output level for the selected input.
You can set this to values between –18.0 dB and +18.0 dB in 0.5dB
increments.
The default value is 0.0 dB.
o If the total of the output level and volume settings exceed 0 dB,
the output level indication will blink.
Lower the output level or volume until it stops blinking.
Note about these settings and sound quality
The left-right balance and output level settings are related to
the volume. This unit's microcomputer analyzes these settings
and the volume level value comprehensively to conduct uni-
fied control of volume amplification.
For this reason, unlike ordinary amplifiers that pass audio sig-
nals through multiple circuits, these settings will not degrade
the audio quality.
16
Phase inversion
(Invert>***)
This can be used to reverse the phase of the audio signal output.
For example, if the XLR output of a device that sends a signal to this
unit's input is 2 HOT, but the XLR input of the device that receives the
signal output from this device is 3 HOT, set this to ON.
By default, this is set to OFF.
OFF
No phase inversion
ON
Phase inversion enabled
o When the polarity has been inverted, the POLARITY indicator
lights to show this.