Panasonic EP-MA73 Mode D'emploi page 56

（Continued）
Q&A
Q
The noise grows louder after using
the chair for a long time.
A
This may be a malfunction. Contact the
nearest authorized service center for
an inspection and repair.
Q
Is there a timer function?
A
Yes.
To prevent overuse, the massage
automatically ends around 16 minutes after
starting. When the timer ends, the leg rest
automatically lowers and the massage heads
are stored.
Press to use again.
◦ Take a break of around 10 minutes after
using for 16 minutes.
◦ Do not use more than twice (30 minutes)
per day.
Q
The leg & sole massage section
doesn't get warm.
A
The "Foot Heat" warms the toe portion
of the cloth. Place feet so that they
are firmly pressed against the "Heat"
(heater) section.
Raise the leg & sole massage section
during use so that soles of your feet
touch this section to feel the heat from
the heater section.
You can also place a blanket over your knees
and lower legs to feel even warmer.
EN56
Other
Q
What precautions should I take to
transport the unit when moving?
A
Take the following precautions:
◦ R ecline the backrest and raise the
massage heads to around the center of
the backrest. This moves the center of
gravity to the center of the unit and makes
it easier to move.
◦ Do not move the chair while a person is
sitting in it.
① Press
to turn the power on.
② Press
to recline the backrest.
Hold down the
two buttons
until long
beeps sound.
③ Select an automatic course when the
power is on.
◦ The massage heads move. An error
occurs and the movement stops when
they reach the center of the backrest.
Massage
heads
④ Press
to turn the power off.
◦ Be sure to press
automatically raises the backrest.
⑤Turn the power switch "off" and remove
the power plug (see page EN45.)
If you need to move the chair with the
backrest upright, follow the steps below.
(1) Follow steps ①→③→④ above and raise
the massage heads to the center.
(2) Turn the controller power on again, raise
the backrest and press
power.
◦ Handle the chair with care. If you do
not have the original box, use packing
materials to prevent damage or vibration.
◦ When packing, check that the power
cord and controller cord are not wrapped
around the main unit and take measures
such as placing them on the seat with
the controller to ensure that they do not
scrape against the ground while moving.
, as
to turn off the