DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance page 97

With the INC (∧) and DEC (∨) keys, the source programme number will be increased or
decreased and the corresponding name will be displayed at the same time. Once the programme
number has been selected, press ENTER and the destination programme number will be
displayed:
With the INC (∧) and DEC (∨) keys again, the number of the source programme will be
increased or decreased. Once the programme number has been selected, press ENTER
If you wish to return to the previous menu you should press the ESC key.
7.3 Change program
This command allows for inserting, changing or removing a block in a programme, The
steps to follow are the following:
After selecting CHANGE PROGRAM, press the ENTER key and the number of the first
available programme will be displayed with its name:
With the INC (∧) and DEC (∨) keys the programme number will be increased or
decreased. Once the programme has been selected, press ENTER.
COPY PROGRAM
Orig. program:
WHITES
Dest. program:
Copy program?
ENTER: Accept
ESC: Cancel
CHANGE PROGRAM
Program:
BLANKETS
CHANGE PROGRAM
Program:
Program name
BLANKETS
53
1
90 ºC
17
21
21