Block; Create Block; Copy Block; Change Block - DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance

36. 20, 22, 24, 26, 28, 30. Delay n
This is the time taken between the detection of water in the tub and the start of dosage of
additive n. The possible values are:
0 to 99 sec. in steps of 1 sec.: delay time in seconds.
Once all the parameters to be introduced are known, we return to the main programming menu.
After pressing the ENTER key we have three options:

6.1 Create block

This command allows for a new block to be created. The steps to follow are the following:
After selecting CREATE BLOCK, press the ENTER key:
With the INC (∧) and DEC (∨) keys, the character where the cursor is can be modified;
with the ADVANCE key (>>) the cursor goes on to the next character; the INFO key
changes from upper to lower case and to special characters. Press ENTER to validate the
selection.
PROGRAM NAME
PHASE NAME

→BLOCK

PROGRAM

CREATE BLOCK
COPY BLOCK
CHANGE BLOCK
CREATE BLOCK
Block
Text:▊
CREATE BLOCK
Block:
Text: wash
Stop programme:
48
35
35
N