Programme Operation - DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance

2.4.-Programme operation

In order to carry out a wash programme, the following steps should be followed:
Put the dirty clothes in the washing machine drum
Close the washing machine door.
Select the desired programme.
Press the START key.
Once the programme has started, information relating to the ongoing programme's status
and function is shown on the screen. For example,
The second line indicates the ongoing phase, in this case a pre-wash. The third line shows
the programmed water temperature. Finally, the fourth line indicates the operation being carried
out at this moment; in the example, the water intake.
When the water intake has finished and the heating starts, this is indicated on the screen, as
can be observed in the following Figure:
After finishing heating the water, the washing time starts, indicating the remaining time on
the screen, as can be observed in the following Figure:
When the phase finishes, the drainage is performed, indicated on the screen, as can be
observed in the following Figure:
P2:WHITES/COLOUREDS 60 ºC
Pre-wash
Temperature:
Filling...
P2:WHITES/COLOUREDS 60 ºC
Pre-wash
Temperature:
Heating...
P2:WHITES/COLOUREDS 60 ºC
Pre-wash
Temperature:
Remain. time:
P2:WHITES/COLOUREDS 60 ºC
Pre-wash
Temperature:
Emptying...
19
30 ºC
30 ºC
30 ºC
4 min
30 ºC