Installation; Installation Diagram; Positioning; Water Connection - DANUBE WED 8 Instructions Pour L'installation, L'utilisation Et La Maintenance

1.1.- Installation diagram

See Figure. 1

1.2.- Positioning

The washing machine must be firmly secured on the floor, which will support
the its weight and the residual force generated while spinning.
After unpacking the washing machine, the pieces that secure the free-floating
part and the chassis during transportation should be removed. In order to do this, the
front and back panels should be removed to access the fixing elements. They are easily
seen as they are red.
It is advisable to secure the washing machine with the screws provided with it.
In order to do so, plastic plugs must be inserted into the previously drilled holes (Fig. 2).
The washing machine must be correctly levelled leaving a space at the back to
facilitate its maintenance.

1.3.- Water connection

If only cold water is available, water connection is carried out as shown in
Figure 3. If hot water is available, connection will be performed as shown in Figure 4. If
decalcified water is also available, connection will be performed as shown in Figure 5.
Necessary dynamic pressure: 2 ÷ 4 Kg/cm

1.4.- Steam connection

If steam is available, heating of washing water will be injected directly. The
connection diagram is shown in Figure 6.
Steam pressure: 2 ÷ 4 Kg/cm
After steam has been introduced into the machine for the first time, it is
advisable for the steam hose nuts to be re-tightened.

1.5.- Drainage

Fix the drainage bend pipe as shown in Figure 7.

1.- INSTALLATION

2
.
14
2
.