To Start/Stop Massage Action - Panasonic EP790 Manuel D'utilisation

TO START/STOP MASSAGE ACTION

Before using, first read all the instructions including the warnings and safety precautions as well as the
section on programmed and manual massage.
<BEGINNING OPERATION>
1. To operate the massager, press the "start/reset" button.
Check to be sure the operation indicator lamp is lit.
Operation indicator
lamp
2. If you wish to stop the massage immediately, press the "stop" button.
The massage heads will stop where they are.
Check to be sure the operation indicator goes out. To restart massage press "start/reset" button.
3. After final use, press the "start/reset" button.
The massage heads will go up, spread out and stop in the restore position. With the heads in this
position you can sit comfortably, using the massager as a regular chair.
Be sure to store the controller in the pocket on the side of the left arm rest when not in use.
Operation indicator
lamp
4. Do you want programmed or manual operation?
If you wish to select a programmed massage, slide the cover down fully and press buttons.
If you wish to select the manual massage, slide the cover upwards fully and press buttons.
With cover slid down fully
Automatic timer for massage lounger
To prevent excessive massaging there is a built-in timer which, after approx. 15 minutes of operation, will
automatically return the massage heads to the "restore" position and stop their motion.
Turning on the operation switch while the massage heads are moving to the "restore" position will reset
the time for another 15 minutes (approximately).
If the programmed massage button is pushed, the unit will stop after finishing the program.
10
With cover slid up fully