Power Connections - Sony XM-GS6DSP Mode D'emploi

Power connections

 Connect the +12 V power supply wire only after all
the other wires have been connected.
 Be sure to connect the ground (earth) wire of the
unit securely to a metal point of the car. A loose
connection may cause a malfunction of the
amplifier.
 When using a car audio unit without a remote
output (REMOTE OUT) for the amplifier, connect
the remote input (REM) terminal to the accessory
power supply.
 Use a power supply wire with a fuse (60 A)
attached.
 All power wires connected to the positive battery
post should be fused within 450 mm (17
the battery post, and before they pass through
any metal.
 Make sure that the car's battery wires connected
to the car (ground (earth) to chassis) are of a wire
gauge at least equal to that of the main power
wire connected from the battery to the amplifier.
 During full-power operation, a current of more
than 60 A will run through the system. Therefore,
make sure that the wires to be connected to the
+12 V and GND terminals of this unit are at least 
8-Gauge (AWG-8) or have a sectional area of
more than 8 mm² ( 11 /
8
GB
3 /
4
in²).
32
Making power connections
Power connection wires (not supplied) are required.
in) of
* Ground (earth) to chassis.
to a metal point of the car
3
less than 450 mm (17 / in)
4
Fuse (60 A)
+12 V car battery
to the car's ACC power line