Sony XM-D1000P5 Mode D'emploi

SERVICE MANUAL
Ver 1.0 2003. 02
AUDIO POWER SPECIFICATIONS (US MODEL)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
500 watts minimum continuous average power into 4 ohms,
20 Hz to 300 Hz with no more than 0.2% total harmonic
distortion per Car Audio Ad Hoc Committee standards.
Other Specifications
Circuit system Class D Technology
Pulse power supply
Inputs RCA pin jacks
High level input connector
Outputs Speaker terminals
Through out pin jacks
Suitable speaker impedance
2 – 8 Ω
Maximum outputs 1,000 W (at 4 Ω)
1,600 W (at 2 Ω)
Rated outputs (supply voltage at 14.4 V)
500 W (20 – 300 Hz, 0.2% THD, at 4 Ω)
900 W (20 – 300 Hz, 0.6% THD, at 2 Ω)
+0.5
Frequency response 5 – 300 Hz (
–3
Harmonic distortion 0.06% or less (at 100 Hz, 4 Ω)
Input level adjustment range
0.3 – 6.0 V (RCA pin jacks)
1.2 – 12.0 V (High level input)
Sony Corporation
9-877-039-01
2003B0400-1 e Vehicle Company
© 2003. 02 Published by Sony Engineering Corporation
XM-D1000P5
SPECIFICATIONS
dB)
Low-pass filter 50 – 300 Hz, –12 dB/oct
Low boost 0 – 10 dB (40 Hz)
Power requirements 12 V DC car battery
(negative ground)
Power supply voltage 10.5 – 16 V
Current drain at rated output : 90 A (at 2 Ω)
Remote input : 2 mA
Dimensions Approx. 347 × 57 × 339 mm
(13 × 2 × 13
3/4 1/4
projecting parts and controls
Mass Approx. 3.8 kg (8 lb. 6 oz.) not incl. accessories
Supplied accessories Mounting screws (5)
High level input cord (1)
Protection cap (1)
Design and specifications are subject to change without
notice.
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
MONAURAL POWER AMPLIFIER
US Model
Canadian Model
AEP Model
UK Model
E Model
in.) (w/h/d) not incl.
3/8
1