Water Ace RTS5 Manuel D'installation page 11

Thread two 1-1/4" male PVC
STEP
adapters into front of packer well
8
adapter. The top hole is for the
delivery pipe. The bottom hole is
for the pressure pipe.
Cement the 1-1/4" to 1" PVC
STEP
reducer to the bottom male PVC
9
adapter on the packer well adapter.
Thread the 1-1/4" male PVC
STEP
adapter into top hole in front of
10
the pump. Thread 1" x 4" nipple
into bottom hole in front of the
pump.
Thread the 1" female PVC adapter
STEP
onto the 1" x 4" nipple.
11
Cement
STEP
as many
12
sections
and
couplings
of 1-1/4"
PVC pipe
as needed to connect top male 1-1/4" PVC adapter on
front of the pump to top male 1-1/4" PVC adapter on
front of packer well adapter. Cement as many sections and
couplings of 1" PVC pipe as needed to connect 1" female
PVC adapter on 1" x 4" nipple to 1-1/4" to 1" PVC reducer
on front of packer well adapter. (FOLLOW STEPS 10–18 IN
THE RC10 4" DIAMETER DEEP WELL PUMP INSTALLATION
INSTRUCTIONS on pages 7 and 8. Complete installation
should look like drawing to the right.)
ALTERNATE PACKER/PUMP CONNECTION FOR
RC10 & RC5
The Adapter Plate RPA connects directly to packer well adapter.
Position adapter plate gasket between pump and adapter plate (large
holes of adapter plate should face away from pump). Bolt adapter
plate to front of pump with two Allen bolts included with Adapter
Plate RPA, then bolt packer well adapter to adapter plate.
Notice: Plastic shipping base is attached to prevent movement in shipment only.
Do not return pump if shipping base becomes cracked in shipment, as pump
1-1/4" MALE
PVC
ADAPTERS
1-1/4" to 1"
REDUCER
1-1/4" MALE
PVC ADAPTER
1" x 4"
NIPPLE
FEMALE
ADAPTER
DELIVERY PIPE
1-1/4" PVC PIPE
1" PVC PIPE
PRESSURE PIPE
performance will not be affected.
1-1/4"
PVC
** Requires RP2 packer ejector kit (sold separately).
PUMP
10
Packer Well
Adapter
Single Pipe
Packer Ejector**
PACKER
WELL
ADAPTER
GASKET
ADAPTER
ADAPTER
ALLEN
PLATE
PLATE
BOLTS
GASKET
PACKER
WELL
ADAPTER
BOLTS
PACKER
WELL
ADAPTER
23833A472