Switching On For The First Time; Adjusting The Dispensed Quantity - Melitta Caffeo SOLO Manuel

4.5

Switching on for the first time

Caution!
The appliance may only be switched on without the Melitta
and with a full water tank.
– Insert the Melitta
®
it on.
– Fill the water tank with fresh tap water to the max. mark before switching
the appliance on.
• Press the ON/OFF
will be illuminated on display. The system needs to be vented to
free all water lines from air. Please place a vessel under the coffee
spout to catch possibly running water.
• Push the button for coffee strength
procedure loud pump sounds may occur because there is no water in
the system. Water runs in the interior of the drip tray of the appliance
and after a brief heating-up phase water runs also out of the coffee
spout. As soon as the beans are illuminated on display the appliance is
ready for operation.
4.6

Adjusting the dispensed quantity

• Turn the coffee quantity regulator (Fig. A, no. 3) to variably adjust the
dispensed quantity (regulator to the left: less coffee, regulator to the
right; more coffee).
Dispensed quantity
For one-cup
dispensing
For two-cup
dispensing
Claris water filter into the appliance only after switching
®
button to switch on the appliance. The symbol
Regulator far
left
30 ml
2 x 30 ml
Claris water filter
® ®
to activate the pump. While this
Regulator in Regulator far
the middle right
125 ml 220 ml
2 x 125 ml 2 x 220 ml
47 47