Filling The Water Tank; Switching On For The First Time - Melitta Caffeo Lattea Guide D'utilisation

4.5

Filling the water tank

Open up the flap of the water tank (Fig. A, no. 7) and pull the water tank
•
up and out of the appliance.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
Note
If the water tank runs empty during operation (e.g. during the coffee dispensing
process), the symbol for the water tank will be illuminated. The current
operation will be stopped and the water tank must be filled before starting a
new operation.
4.6

Switching on for the first time

All of the tubes have been drained and aired out at the factory. For this reason, the
first time the appliance is switched on, the symbol for the milk shower
illuminated after the heat-up phase and the appliance must be vented via the milk
shower.
Caution!
The appliance may only be vented without the Melitta
with a full water tank.
– Insert the Melitta
Fill the water tank with fresh tap water to the max. mark before venting.
–
• Press the ON/OFF button
→ The standby symbol
After heating up, the symbol for the milk shower
• Remove the milk canister and place a larger vessel under the milk
shower.
Turn the rotary switch for the milk shower (Fig. A, no. 11) clockwise to
•
open the milk shower.
→ The symbol for the milk shower
under the milk shower.
50
Heft_Lattea_EU_2_3.indd 50
Claris water filter into the water tank only after venting.
® ®
to switch the appliance on.
is flashing. The appliance heats up.
is flashing. Water runs into the vessel
will be
Claris water filter and
® ®
will be illuminated.
09.04.2014 14:04:18