Installing The Appliance; Connecting The Appliance; Switching On And Venting The Appliance For The First Time - Melitta PASSIONE Mode D'emploi

First steps
3.3

Installing the appliance

Observe the following instructions:
ū Do not install the appliance in damp rooms.
ū Install the appliance on a stable, flat and dry surface.
ū Do not install the appliance in the vicinity of sinks or the like.
ū Do not install the appliance on hot surfaces.
ū Install the appliance at a sufficient distance (approx. 10 cm) from the
wall and other objects. The space above the appliance should be at least
20 cm.
ū Route the power cable so it cannot be damaged by edges or hot sur-
faces.
3.4

Connecting the appliance

Observe the following instructions:
ū Make sure that the supply voltage matches the operating voltage speci-
fied in the technical data (see the Technical data on page 97 table).
ū Only connect the appliance to a properly installed earthing contact
socket. If in doubt, consult a specialist electrician.
ū The earthing contact socket must have a fuse of at least 10 A.
3.5

Switching on and venting the appliance for the first time

Once you switch on the appliance for the first time, the appliance performs
automatic rinsing. Hot water first flows out of the Cappuccinatore, then out
of the outlet. The appliance is vented.
CAUTION
Hot water and hot steam flowing out of the pipe
Do not touch the steam pipe during and immediately after use.
ƒ
Wait until the steam pipe has cooled down.
ƒ
Information
ū We recommend pouring away the first two cups of coffee after initial
start-up.
ū If you want to use a water filter, only insert this after starting up for the
first time.
62