Connecting The Appliance; Switching On The Appliance For The First Time; Basic Operation; Switching The Appliance On And Off - Melitta Purista 300 Série Mode D'emploi

ū Install the appliance on a stable, flat
and dry surface.
ū Do not install the appliance in the vicin-
ity of sinks or the like.
ū Do not install the appliance on hot
surfaces.
ū Install the appliance at a sufficient
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.

3.3 Connecting the appliance

Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in the
technical data (see table Technical data
on page 51).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The earthing contact socket must have
a fuse of at least 10 A.
3.4 Switching on the appli-
ance for the first time
Once you switch on the appliance for the
first time, the appliance performs auto-
matic rinsing. Hot water flows out of the
outlet. The appliance is vented.
Information
ū We recommend pouring away the first
two cups of coffee after initial start-up.
ū If you want to use a water filter, only
insert this after starting up for the first
time.
Fig. 4: ON/OFF button
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button (15).
3. Open the lid of the water tank and
4. Rinse out the water tank with clean
5. Insert the water tank into the appliance
6.
7. Once no more water flows out of the
8. Fill coffee beans into the bean con-
9. As required, you can now either
4
4.1 Switching the appliance
15
Before switching on after starting up the
appliance for the first time, read sec-
tion 3.4 Switching on the appliance for the
first time on page 35.
The Ready display lights up
»
briefly.
The Water display lights up and
»
requests you to fill the water tank.
pull the water tank upwards out of the
appliance by the handle.
water. Fill the water tank with fresh
water.
from above and close the lid.
The Vent display lights up and
»
requests you to vent the appliance.
Press the "Coffee strength" button.
» Water flows into the drip tray.
» The appliance heats up and hot
water flows out of the outlet.
outlet, the Coffee bean display lights up.
» The appliance is vented.
tainer (see section 4.3 Filling coffee
beans into the bean container on
page 11).
a) set the water hardness (see sec-
tion 6.3 Setting the water hardness on
page 41) or
b) screw in a water filter (see sec-
tion 7.5 Using a water filter on
page 48).

Basic operation

on and off
Basic operation
35