Attachment And Operation; Working Instructions - Elem Garden Technic THE500SP Traduction Des Instructions D'origine

Attachment and operation

ATTENTION! Before working
on the device - cleaning, in-
spection, maintenance or
other work - always turn off
the device and separate it
from the power supply.
ASSEMBLY
Assembling the motor casing (Fig. 2)
• Open the qick acting lock (11) from the
motor casing (9).
• Insert the telescopic tube (6) into the
casing's holding fixture.
• Close the casing's quick acting lock (11)
again,
Attaching the shoulder strap, Fig. 3
Assembly and use:
• Fix the shoulder strap on the flap (4)
• By changing the adjuster, the length of the
shoulder strap can be altered. Adjust the
length of the shoulder strap in such a way that
it ensures a comfortable working posture.
• Put the shoulder strap over your right
shoulder.
• Carry the tool's motor on the right side of
your body.
Never put the shoulder strap over your
shoulder and across your chest, but put it
on one shoulder.
In this way, you will be able to quickly
remove the tool from your body in case of
mergency.
original manufacturer's
ment parts, accessories
and attachments. Failure
to do so can cause poor
performance, possible
injury and may void your
warranty. Never use the
out the guard assembled!
Warning! Use only
replace-
machine with-
Starting and stopping the telescopic hedge
trimmer, (Fig. 4)
• Starting the device: First, press the safety
switch (3) on the back handle left, then the
trigger (2). After starting the motor, you can
release the safety switch (3).
• Stopping the device: Let go of the trigger (2).
Adjusting the telescopic tube (Fig. 5)
Disconnect the tool from the electricity
supply first !
• Open the locking handle (5) for length
adjustment
• Adjust the telescopic tube (6) to the required
length.
• After the adjustment, close the locking
handle (5) again, so that the length adjustment
is secure.
Adjusting the motor head (Fig.6)
Disconnect the tool from the electricity
supply first !
Angle adjustment A
• Press the button (10) for the angle
adjustment on both sides and rotate the head
to the required position (from 0° to 120°). Make
sure that the motor head clicks into place
again.
Make sure that the adjustment buttons return
to their initial position after adjustment.
Otherwise, the tool will not start.
Do not connect the tool to the electricity supply
until assembly has been completed. If this is
not done, the device could start unintentionally
and cause severe injuries.

Working instructions

NOTICES AND TIPS FOR HEDGE TRIMMER
• Find safe footing, operate the device with
both hands and turn it on.
• Cut the hedge from both sides and start at
the bottom.
In this way, you can prevent cutting-waste
falling into the area that still needs to be cut.
• Guide the device gently through the area of
the hedge.
• Do not attempt to cut too deeply.
• Then cut the upper part of the hedge.
• For older hedges which need more pruning,
cut stronger branches and twigs with loppers
before cutting the hedge with the device.
32