Standard Installation - Bosch Power Xpress Dual Bollard Instructions D'installation

en | 6 | Power Xpress™ Dual Bollard Charge Station Installation Guide
selector (positioned just above the reset button on
the front of the EVSE).
3. Using a small, flat-blade screwdriver, set the cur-
rent-adjustment selector to the applicable output
current-limiting setting.."
NOTE: Positions 6, 7, 8, 9, 0 are not used (X) and
are non-operational. The EVSE will not
function under these settings.
WARNING: The EVSE setting cannot
exceed ampacity ratings of field service
wires or branch circuit protectors.
WARNING: See "output" specification
label located on the side of the EVSE
for maximum amperage setting, per
limitations of vehicle cable and coupler.
NOTE: The EVSE must be de-rated to match line
service power limitations.
CAUTION: Use 75°C (600V) approved wire,
conductor temperature at 30°C ambient in
wet or dry locations.
576414 | REV. B | 28.10.2016

8.0 Standard Installation

1. Lay down the bollard box and remove the banding.
2. Lift the top off the box and remove the bollard from
the packaging material.
3. Remove the upper cover from the bollard assembly
by removing the cable-management retaining screws
(E) on the rear of the bollard.
4. Remove plastic bag containing locating set screw
(not shown) from inside bollard.
NOTE: The upper and lower plastic bollard covers
are a matched set and cannot be used
inter-changeably with those from other
bollards.
The standard installation design for the Power Xpress
Bollard is a bolt-down external plate.
The standard diameter of the bollard is approximately 7
Bosch Automotive Service Solutions Inc.