Bosch Power Xpress Dual Bollard Instructions D'installation page 11

17. Pass the charging cable through the exit hole on the
side of the bollard.
18. Feed the cord past the side of the EVSE and slide
into position.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Dual Bollard Charge Station Installation Guide | 9 | en
19. Install cord into top wiring chamber of the top unit.
20. Tighten fasteners on the back of the bollard.
21. While tightening the fasteners guide the EVSE's so
that the bottom cover is resting on the ledge of the
bollard.
NOTE: The fasteners will force the EVSE's snuggly
against the bollard.
576414 | REV. B | 28.10.2016