Troubleshooting - Bosch Power Xpress Dual Bollard Instructions D'installation

- No illumination
- Solid illumination
- Flashing illumination

10.0 Troubleshooting

If there is a charging issue proceed with the following
steps. If the issue persists after three attempts call Bosch
at 1-877-805-EVSE (3873) for assistance.
Problem Solution
Indicated
by LED
Status
Pilot charg- 1. Verify supply-side power. The green
ing error POWER LED should be on. If green
POWER LED is off, locate load
center/panel and reset breaker.
2. Press the master clear RESET button
on the front panel of the Charge
Station to attempt a charge-restart.
3. If the red STATUS LED remains
on, disconnect the Charge Station
coupler from the vehicle charge port,
wait 10 seconds, and reconnect the
coupler.
Ground 1. Disconnect main service power at
fault service panel.
detected 2. Disconnect
coupler from the vehicle.
3. Inspect
connector and the vehicle charge
port verifying both are clean and
undamaged. If vehicle charge port
needs cleaning, follow manufacturer
instructions
Charge Station connector with a dry
or damp cloth if necessary.
4. Restore main service power.
5. Reconnect the coupler to the vehicle
port.
Ground 1. Disconnect main service power at
monitor service panel.
interrupted 2. Disconnect
coupler from the vehicle.
3. Inspect
connector and the vehicle charge
port verifying both are clean and
undamaged. If vehicle charge port
needs cleaning, follow manufacturer
instructions
Charge Station connector with a dry
or damp cloth if necessary.
4. Restore main service power.
5. Reconnect the coupler to the vehicle
port.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Dual Bollard Charge Station Installation Guide | 15 | en
the Charge Station
the Charge Station
for cleaning. Clean
the Charge Station
the Charge Station
for cleaning. Clean
576414 | REV. B | 28.10.2016