Bosch Power Xpress Dual Bollard Instructions D'installation page 15

39. Attach safety ground wire through the slot on the
ground terminal. Hand-tighten grounding lug.
NOTE: See inside of wiring chamber cover for
wiring schematic.
40. Tighten terminal screws to 1.2 Nm (10.62 in-lb).
41. Reinstall strain relief.
NOTE: Select appropriate orientation of insert
to achieve proper clamping for wire size
used.
CAUTION: Do not overtighten.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Dual Bollard Charge Station Installation Guide | 13 | en
42. Attach the wiring chamber lid with four (4) 3/4 in. (20
mm) square-drive screws.
43. Apply the self-adhesive chamber lid label.
44. Switch the main circuit breaker to the ON position and
verify that the Power LED is illuminated solid green and
the Status LED is illuminated solid amber on the EVSE.
45. Place both halves of the plastic base cover over bollard
base. Secure with plastic push pins
576414 | REV. B | 28.10.2016