Bosch Power Xpress Dual Bollard Instructions D'installation page 14

en | 1 2 | Power Xpress™ Dual Bollard Charge Station Installation Guide
34. Trim the wire to a length sufficient to make the
connections to the Charge Station terminal block.
35. Strip back 1 1/4 in. (32 mm) of the wire jacket and
3/8 in. (10 mm) from the ends of the individual
conductors.
576414 | REV. B | 28.10.2016
36. Remove threaded ground lug.
37. Feed the L1 wire into the L1 terminal slot in the wiring
chamber.
38. Feed the L2 wire into the L2 terminal slot in the wiring
chamber.
Bosch Automotive Service Solutions Inc.