Connections Connectors - Brink Renovent Excellent 300 Consignes D'installation

Electric connections accessories

11.1 Connections connectors

Connector X1
Connector X2
1 2 3 4 5 6 7 8 9
Not suitable for
230V!
X-15
Renovent Excellent
eBus or. OpenTherm connector X1
Two-pole screw connector.
Set ex factory as eBus connector; after modifying parameter 8 in
the Settings menu, also suitable as OpenTherm connector (see
§11.3). Only suitable for low voltage
Note:
Modular connector X2 for rpm control
Modular connector type RJ-12.
Only suitable for low voltage
Connector X14 for connecting postheater
Two-pole screw connector (accessible after taking off display
cover).
Ex factory this connector is not activated; after changing para-
(postheater), this connector can be used for connecting the pos-
theater or preheater
Maximum rated power is 1000W.
Note: The postheater temperature sensor must also be con-
nected to X15-7 and X15-8.
For the Plus version, use the additionally mounted pull relief in
the display cover to feed the 230 V cable to the postheater.
Connector X15 for connecting special versions
Connection Application
1 & 2 Stepnr. 15 = 0: normally open contact
(input 1) Stepnr. 15 = 1: 0 - 10V input 1; X15-1=GND &
Stepnr. 15 = 2: normally closed contact
Stepnr. 15 = 3: input 1/ bypas open
Stepnr. 15 = 4: input 1/ bypas open
3 & 4 Stepnr. 21 = 0: normally open contact
Stepnr. 21 = 1: 0 - 10V input (= factory setting)
(input 2)
Stepnr. 21 = 2: normally closed contact
Stepnr. 21 = 3: input 2/ bypas open
Stepnr. 21 = 4: input 2/ bypas open
5 & 6 Conn. 24 volt , 4.5 VA maximum (5 = ground , 6 = +)
7 & 8 Connection postheater sensor or and
outdoor geo heat exchanger
9 Control signal valve 0 or 10 V ( 9 = + , 5 = ground)
Chapter 11
(= factory setting) §11.7)
15 - 2 = 0 - 10V (see §11.8)
12V;
bypass closed 0V
0V;
bypass closed 12V
(see §11.8).
12V;
bypass closed 0V
0V;
bypass closed 12V
31