Replacing The Lamp; Closing The Door - AEG S94400CTM0 Notice D'utilisation

16 www.aeg.com
Problem
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
Technical problems
Upper or lower
square is shown in
the temperature Dis-
play.
dEMo appears on
the Display.

6.1 Replacing the lamp

CAUTION!
1

6.2 Closing the door

1. Clean the door gaskets.
Possible cause
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
electrical malfunction
An error has occurred in
measuring the tempera-
ture
The appliance is in dem-
onstration mode (dEMo) .
2
Solution
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Contact Customer Serv-
ice Department
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
Disconnect the plug from the mains
socket.
1. Press on the rear hook of the lamp
cover by a screwdriver and at the
same time pull and rotate the cover
in the direction of the arrow.
2. Replace the lamp with one of the
same power and specifically de-
signed for household appliances.
(the maximum power is shown on
the light bulb cover).
3. Fix the lamp cover into its original
position.
4. Connect the plug to the mains sock-
et.
5. Open the door. Make sure that the
light comes on.
2. If necessary, adjust the door. Refer
to "Installation".