Hamilton Beach Commercial HVC406-CE Manuel D'utilisation page 10

Maintenance
Visit http://www.hamiltonbeachcommercial.com/en/technical-services-how-to-videos.html for directions
on changing oil and replacing parts.
Inspect vacuum sealer and its various parts and replace as follows:
Weekly
• Check oil by looking at the oil indicator.
• Check seal pad under lid for wear.
• Check lid gasket and lid.
• Check seal bar for wear.
Every 6 Months
• Replace oil in vacuum pump. Contact Technical Services.
• Replace seal pad under lid.
• Replace lid gasket.
• Replace sealing tape and sealing wires.
Yearly
• Check oil exhaust filter. Contact Technical Services.
Cleaning
Inspect the vacuum sealer and its various parts and clean as follows:
Run the Preheating Program
• Run the Preheating Program daily. See page 6.
Clean Inside and Outside
• Unplug unit.
• Let unit cool completely before cleaning.
• Wipe vacuum chamber, lid, sealing bar, silicone holder, and exterior with a clean, moist cloth.
• Do not use abrasive materials, scratching cleansers, or scouring pads to clean since these may damage
the finish or spoil the clarity of the lid.
• Wipe off all mild soap and chemical cleansers since residue may corrode the finish.
Tips
Vacuum Confirmation
• To check quality of vacuum, check tightness of the pouch and its contents. Check for air leaks and
pockets. If you find that contents are not tightly vacuumed, increase the vacuum time by
5 seconds and run the vacuum again.
Seal Confirmation
• To check quality of the seal, check seal of pouch. A complete seal will appear clear while an incomplete
seal will appear bubbly. If the seal is incomplete, increase seal time by 0.1 second. If the seal appears
white, decrease seal time by 0.1 second. After determining the appropriate time adjustments, vacuum
and seal again.
10