sylvac PLC Mode D'emploi page 19

11. List of the main commands
Selection and configuration
CHA+ / CHA- Change measurement direction
FCT0 ...9...A...F Assign «favourite» function
MM / IN Change measurement unit
KEY0 / KEY1 Lock / unlock keypad
MUL [+/-]xxx.xxxx Modify multiplication factor
PRE [+/-]xxx.xxx Modify preset value
REF1 / REF2 Change active reference
STO1 / STO0 Activate / de-activate HOLD
TOL1 / TOL0 Activate / de-activate tolerances
LCAL dd.mm.yy Modify last calibration date
NCAL dd.mm.yy Modify next calibration date
NUM xxxxxxxxxx Modify the instrument number
TOL +/-xxx.xxx +/-yyy.yyy Inputting tolerance limits
RS232 baud, N, P, S [CRLF] RS-232 port parameter selection
RS485 baud, N, P, S [CRLF] RS-485 port parameter selection
BUS MODBUS/ASCII/ORBIT Protocol selection
SLA aaa MODBUS address selection
MIN /MAX /DEL /NOR Selecting MIN, MAX, Delta, Normal mode
CLE Re-initialisation of MIN, MAX or Delta
UNI1 / UNI0 Activate / de-activate change of units
OUT1 /OUT0 Activate / de-activate contin. data transmission
PRE ON / PRE OFF Activate / de-activate Preset function
PRE Recall Preset
SET Zero reset
RES2 / RES3 Change of resolution
Interrogation
CHA? Measurement sense?
FCT? «favourite» function active?
UNI? Measurement unit active?
KEY? Keypad locked?
MUL? Multiplication factor?
PRE? Preset value?
REF? Reference active?
STO? Status of HOLD function?
TOL? Current tolerance limit values?
LCAL? Date of last calibration?
NCAL? Date of next calibration?
NUM? Instrument number ?
? Current value (mode Tol, value followed by <=>)
RS232? RS-232 port parameter?
RS485? RS-485 port parameter?
BUS? RS-485 bus protocol?
SLA? MODBUS address?
MOD? Active mode (MIN, MAX, Delta or Normal)?
SET? Main instrument parameters?
ID? Instrument identification code?
Maintenance functions
OFF Switch-off (wake up using a button or RS)
RST Re-initialisation of the instrument
VER? Version No. and date of firmware
19
E