sylvac PLC Mode D'emploi page 13

6. Favourite key
The «favourite» key gives direct access to a predefined function, and can be configured according to the needs of the
user. In order to assign a function to the «favourite» key, give a prolonged press on
function :
Data
0 dAtA
transmission
(default)
1 HoLd
Hold display
2 CLr Re-initialise Min
-Max-Delta
3 SEt
Zero reset
Validation of selection: By a prolonged press on
Note : a function can also be assigned via RS232 using the command <FCT + Function No.>
example : Change of Unit = <FCT4>
4 Unit
mm – IN
Reference
5 rEF
selection
6 PrE
Recall preset
or a short press on
13
, and then select the required
Nor-Min-
7 ModE
Max-Delta
8 toL
Tol ON -
Tol OFF
9 rES
0.01 - 0.001
0.001 - 0.0001
or
SET MODE
Measurement sense,
10 dir
positive - negative
11 MUL
Multiplier
12 bUS
Bus
E