Christopeit Sport Hantelbank POWER XL Notice De Montage Et D'utilisation page 18

Step 4:
Installation of the butterfly arms (5) with round pad holder 1 (4) at the
rear feet (1) with the hexagonal screws (43), washers (52), spacer nut
(37), and handgrip nut (65).
1. Place the parts named above near the feet (1). Insert two sliding
bearings (25) in the middle of the butterfly arm (5). Put a washer (52)
on a screw (43), push the screw through the bearings and screw on a
nut (37) from the back.
(Note: Tighten the nut (37) only sufficiently to allow the screw (38) to
be easily turned.)
2. Push the end of screw (43) through the corresponding hole in the right
foot (1). Put on a washer (52), screw on a the handgrip nut (65) and
tighten firmly.
(Note: The butterfly arm (5) must move easily after installation.)
3.
Insert the round pad holder 1 (4) into the butterfly arm (5) and push
one round pad (20) to fix it.
4. Install the second butterfly arm (5) and one round pad holder 1 (4) at
the other side on rear foot (1) as described in 1. - 3. The distance of
round pads (20) is adjustable by using another hole for fix them.
5. Finally, push a spring circlip 1 (27) on the bar bell weight holders of the
butterfly arms.
Step 5:
Installation of the leg curler (10), the round pad holders (19) and the
round pads (20) on the front foot (8) with the shaft piece (44) and the
Allen screw (55).
1. Insert the leg curler in the holder of the foot (8). Align the holes in the
holder and the sliding bearings. Push the shaft piece (44) through
from one side. From the opposite side, screw the screw (45) into the
threaded
hole of the shaft piece and tighten firmly.
(Note: After installation, the holder of the foot (8) must not be bent and
the leg curler must move easily.)
2. Push the two round padding holders (19) centrally into the correspon-
ding holes of the leg curler (10). Push on a round pad (20) from each
side.
3.
Finally, push a spring circlip 1 (27) on the bar bell weight holders of the
leg curler (10).
18