Changing Operating Modes - EYENIMAL PFABOSTI048 Guide D'utilisation

To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
Diagram 3
Activate/deactivate the collar
with the magnetic key
• Operation
After activating the collar, it remains on standby for 30 seconds to allow you time to fix the collar on your dog.
At the first bark, a beep sound is emitted. If another bark is detected within 30 seconds, another beep sound is emitted
together with a static correction (light, progressive or strong static correction according to the selected operating mode). Inhibition of any further
static correction is dependent on the absence of any barking within the next 30 seconds.
If your dog stops barking during 30 seconds, at the next bark, the collar will start its operating cycle from the beginning (beep
sounds only).
The static correction function can be inhibited selecting operating mode Nr 1. In this case, only beep sounds will be
emitted.
After being activated 5 times in quick succession, the collar will automatically go into safety mode for 2 minutes (the
indicator light flashes in red twice every 4 seconds) before restarting itself normally.

• Changing operating modes

In the factory, the collar is set to mode Nr 2 (beep sound + light static correction for sensitive dog).
To change the collar's mode, proceed in the following way:
When switching on the collar, keep the magnetic key in contact with the red mark located on the front of the collar (See
Diagram 3).
After the beep sound indicating that the collar is on, a series of beep sounds together with indicator light flashes is emitted
(from 1 to 4) indicating the selected mode.
Keep the magnetic key in contact with the red mark to run through modes.
Remove the magnetic key when you have reached the mode you wish. The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of beep sounds together with indicator
light flashes emitted when switching mode
4
U DELUXE STATIC NOBARK CONTROL indB.indd 4 U DELUXE STATIC NOBARK CONTROL indB.indd 4
1
2
3
4
Mode
Nr 1
Nr 2 Beep sound + light static correction (sensitive dog)
Nr 3 Beep sound + progressive static correction
Nr 4 Beep sound + strong static correction (difficult dog)
Magnetic key
Operation
Beep sounds only
11/05/2020 10:2 11/05/2020 10:2