Changing The Contact Points; Fitting The Collar; Cautions For Use - EYENIMAL PFDRESTI291 Guide D'utilisation

● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with the dog's
skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace them with the
long ones supplied with the kit. Carefully tighten them manually (do not use a key).
● Fitting the collar
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
▪
If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your dog. Furthermore, it will not
function correctly.
▪
If the collar is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
Do not leave the collar positioned at the same place for long periods (i.e. over 3 hours) because this can cause irritations. If your dog must carry
the collar for long periods, change regularly the position around the neck of your dog.
● Cautions for use
▪
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
▪
Children should be supervised to ensure they do not play with the appliance.
▪
The receiver collar is totally waterproof. Your dog can swim in water.
▪
The remote control is shower proof only: it is only designed to remain a short time in the rain. Put it safe from water as soon as possible.
If the remote control falls into the water, it could be damaged in an irreversible way.
▪
Your dog should not wear any medal, metallic collar, or any other kind of collar together with the training collar.
▪
Avoid placing the remote control close to objects sensitive to magnetic fields which could be irreversibly damaged.
▪
Do not place or keep the unit in places exposed to high temperatures.
▪
EYENIMAL advises to use the same type and same brand of batteries as those supplied in your new purchased product. Other
brands of batteries may not operate or may not be completely compatible with your product. You can purchase the suitable
batteries from EYENIMAL or from your distributor.
▪
It is necessary to replace the batteries every two years, even if the unit has not been used for long periods.
▪
Never leave a discharged battery in the unit (remote control and collar): leakage could damage your product.
▪
Remove the battery from the receiver collar and the remote control if you are not using the appliance for 3 months or more. The collar
will memorize the configuration chosen (coding).
● Maintenance
▪
Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and neutral detergent.
▪
In order to maintain water tightness, we recommend the replacement of the seal located in the receiver collar every year.
● Troubleshooting
Should your product stop working or develop a fault, first read this guide over, then check the batteries and replace them if necessary and retry.
Also check that you are using the product correctly.
If you encounter any problem, re-code the receiver collar with the remote control (ref. Coding procedure).
Re-initialize the system as follows:

Remove the collar battery from its housing

With a metallic tool (e.g. screwdriver, scissors) touch each of the 2 battery
contacts for 2 seconds approximately (ref. Diagram 6)

Insert the battery again: one beep is emitted indicating the battery is in
correct position

Restart your receiver collar using the remote control.
Reset: connect the 2 supports of the battery
Diagram 6