Setting The Speed Of The Camera Movement To A Preset Position - Sony BRC-H900 Mode D'emploi

4
While holding down the PRESET button (for
POSITION 1 to 8) or the SHIFT and PRESET
buttons (for POSITION 9 to 16), press any of the
POSITION buttons in which you want to store the
settings.
While holding down (for POSITION 1 to 8)
RESET
PRESET
1
SHIFT
9
While holding down (for POSITION 9 to 16)
The settings are stored in the memory of the
camera.
The pressed button flashes during storing. Flashing
stops when storing is completed.
To recall the stored settings
Press any of the POSITION buttons in which you have
stored the settings.
For POSITION 9 to 16, hold down the SHIFT button
and press any of the POSITION buttons.
To cancel the preset memory
While holding down the RESET button (for POSITION
1 to 8) or the SHIFT and RESET buttons (for
POSITION 9 to 16), press the POSITION button from
which you want to cancel the settings.
While holding down (for POSITION 1 to 8)
RESET
PRESET
1
SHIFT
9
While holding down (for POSITION 9 to 16)
The pressed button flashes during canceling of the
settings. Flashing stops when the settings have been
canceled.
Notes
• When the power is turned on, the camera starts with
the settings stored in POSITION 1.
• If you want to retain the previous pan and tilt positions
when the power is turned off and turned on again, store
those positions in POSITION 1.
• When you are storing or canceling the settings in one
POSITION, you cannot call up, store or cancel the
settings in another POSITION.
• Before you store camera settings such as camera
position, zooming, focusing, etc., in the memory,
54
GB
Storing the Camera Settings in Memory – Presetting Feature
Press a POSITION button.
2 3 4 5 6 7 8
10 11 12 13 14 15 16
Press a POSITION button.
2 3 4 5 6 7
10 11 12 13 14 15 16
install the camera suitably and fix the camera securely.
If you change the installation of the camera after
storing, differences may arise on the preset.
• For details about the setting items that you can store/
erase, see "Presetting Items" on page 78.
Setting the Speed of the Camera
Movement to a Preset Position
You can select the panning/tilting speed when the
camera moves to a preset position.
1
Press the CAMERA button to select the camera
whose speed you want to set.
2
Press the POSITION button for which you want to
set the speed for more than one second.
All the CAMERA buttons, 1 to 7, flash.
3
Press one of the CAMERA buttons to select the
speed.
CAMERA button
1
2
3
4
5
6
7
Now the camera will move to the position preset to
the pressed POSITION button with the selected
speed.
8
To set the camera's movement speed to a
preset position between 9 and 16
Hold down the SHIFT button and press the
corresponding POSITION button for more than one
second. The POSITION 1 to 8 buttons can be used for
positions 9 to 16.
Panning/tilting speed
1 degree/sec.
2.2 degrees/sec.
4.8 degrees/sec.
11 degrees/sec.
23.3 degrees/sec.
43 degrees/sec.
60 degrees/sec. (default)