Remote Commander (Supplied) - Sony BRC-H900 Mode D'emploi

1 Switch 1, 2 (signal format selector)
Depending on the setting of the Switch 1, 2, the
signal format is changed as follows:
Signal 1080/
format 59.94i
Switch 1 OFF
Switch 2 OFF
2 Switch 3 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
3 Switch 4 (Communication baud rate selector)
Set to ON for 38,400 bps, or OFF for 9,600 bps.
4 Switch 1, 2, 3 (Camera address selectors)
Set the address of the camera.
Normally set to "0". With this setting, addresses are
assigned to the cameras automatically in the
connected order by pressing the POWER button
while holding down the RESET button on the RM-
BR300 Remote Control Unit.
You can assign the camera address "1" to "7"
manually by setting these selectors as follows:
Camera 0 1
address
Switch 1 OFF ON
Switch 2 OFF OFF ON
Switch 3 OFF OFF OFF OFF ON
5 Switch 4 (Infrared signal output switch)
Set to ON to enable an infrared signal output, or
OFF to disable the output. For details about the
output connector, see "Pin Assignments" on page
85.
Note
Set the switches before you turn on the power of the
camera. The switch 4 (Infrared signal output switch)
setting is effective whenever you change its setting.
20
GB
Location and Function of Parts
1080/50i 720/ 720/50p
59.94p
ON OFF ON
OFF ON ON
2 3 4 5 6
OFF ON OFF ON OFF ON
ON OFF OFF ON ON
ON ON ON

Remote Commander (supplied)

7
A CAMERA SELECT buttons
Press the button corresponding to the camera you
want to operate with the Remote Commander.
The camera number can be set using the IR
SELECT switch on the rear of the camera.
Note
If two or more cameras are adjacent and have the
same camera number, they are operated
simultaneously with the same Remote Commander.
When you install the cameras close to each other,
set different camera numbers.
For the camera number setting, see "Operating
Multiple Cameras with the Remote Commander"
on page 45.
B FOCUS buttons
Used for focus adjustment.
Press the AUTO button to adjust the focus
automatically. To adjust the focus manually, press
the MANUAL button, and adjust it with the FAR
and NEAR buttons.
POWER
6
CAMERA SELECT
1
1 2 3
FOCUS
AUTO MANUAL
2
FAR NEAR
DATA SCREEN BACK LIGHT
7
3
STD REV
1 2 3
8
4 5 6
PRESET RESET
POSITION
PAN-TILT
4
HOME
PAN-TILT
RESET
9
SLOW ZOOM FAST
T T
q;
W W
L/R
DIRECTION SET
5
RM-EV100