Operating A Brc-H900 Camera From A Long Distance - Sony BRC-H900 Mode D'emploi

Operating a BRC-H900 Camera from a Long Distance

This system allows you:
• To operate the camera remotely from a distance up to 2,000 m (6,562 feet)
• To perform pan/tilt and zoom operations using the joystick
• To transmit the video and control signals of the camera to a distant place using the Optical Fiber Cable
System configuration
BRC-H900
Video signal
Remote control (VISCA) signal
,
Notes
• Be sure to turn on the power of the BRC-H900 camera before you turn on the power of the BRU-SF10 HD Optical
Multiplex Unit.
• The BRC-H900 camera does not operate if nothing is connected to the BRBK-SF1 HD Optical Multiplex Card
inserted into the camera. To operate the camera, connect the BRU-SF10 Optical Multiplex Unit to the BRBK-SF1
using the CCFC-S200 Optical Fiber Cable and turn on the power of the BRU-SF10.
• When the BRBK-SF1 HD Optical Multiplex Card is inserted into the BRC-H900 camera, the EXT SYNC IN
connector, VISCA RS-232C IN/OUT connectors, and VISCA RS-422 connector on the rear of the camera are
disabled. Use the connectors and switches on the rear of the BRU-SF10 Optical Multiplex Unit instead.
• The optional CCFC-M100 and M100HG Optical Fiber Cable cannot be used with this system.
14
GB
System Configuration
CCFC-S200 Optical Fiber Cable
BRBK-SF1 HD Optical Multiplex Card
Signal flow
HD video monitor
BRU-SF10
Optical Multiplex
Unit
RM-BR300 Remote Control Unit